Hi,

Had a question when AT&T pulls PM data. Like below:

Code
    Display Equipment configuration data AC=2            Data Retrieved
at:  2010-01-14 11:51:32

       TACC Port: 
         A-Z AID: 9-10-16                    Z-A AID: 35-28-10
             AIS: Enabled                        AIS: Enabled
          Alarms: Enabled                     Alarms: Enabled
    Frame Format: ESF/ANSIATT           Frame Format: ESF/ATT
       1st State: In Service               1st State: In Service
       2nd State: Active                   2nd State: Active
      Collect PM: Yes                     Collect PM: Yes
       T3 Failed: No                       T3 Failed: No
1st what A-Z Aid and the numbers after it?
2nd:
Code
performance data: TP = 1
                  CST               ES     UAS     BES     SES    LOFC
   Current Interval (29 secs):       0       0       0       0       0
     11:30:00 AM - 11:45:00 AM       3       0       1       2       0
     11:15:00 AM - 11:30:00 AM       0       0       0       0       0
     11:00:00 AM - 11:15:00 AM       1       0       0       1       0
     10:45:00 AM - 11:00:00 AM       3       0       1       1       0
                  Current Day:      30       0       2      27       0
                 Previous Day:     129       0       5     119       0
Valid 15 minute intervals: 20 = 5 hrs 0 min
Status: Normal Signal
When they pull this, how do i know if thats incoming or outgoing errors?
on ticket its stating showing slow errors
Thanks

Bob