|
Joined: Oct 2003
Posts: 694
Member
|
OP
Member
Joined: Oct 2003
Posts: 694 |
I have a telrad db6 400 cabinet that all lines are on a t1. Everytime I make a programming change, the system doesnt recognize it until I shut it off and then back on again. This usually causes my ons card to loss a couple of extentions, or key phones go out of sync. I believe that there are enough resources available. Any ideas would be great.
Shawn Connect Telecom www.connecttelecom.us In matters of style, swim with the current. In matters of principle, stand like a rock. Thomas Jefferson
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
Joined: Mar 2001
Posts: 7,350
RIP Admin
|
RIP Admin
Joined: Mar 2001
Posts: 7,350 |
Take a look at your Unit Info and make sure you haven't excided your Power Ports
Russ runs a local service and private tech center. [/url]
|
|
|
|
Joined: Aug 2002
Posts: 4,925 Likes: 1
Administrator
|
Administrator
Joined: Aug 2002
Posts: 4,925 Likes: 1 |
are you doing online programming and loading with F5? Have you made sure of your load area used?
|
|
|
|
Joined: Jun 2001
Posts: 10,631
RIP Admin-Founder
|
RIP Admin-Founder
Joined: Jun 2001
Posts: 10,631 |
Check your resources in maintenance.
|
|
|
|
Joined: Oct 2003
Posts: 694
Member
|
OP
Member
Joined: Oct 2003
Posts: 694 |
Thanks for the help. Here are my resouces. power ports 41 free trunks 89 free stations 195 free highways 19
I am new to the telrad and dont completely understand the power port thing. And I am doing online programming and saving with f5.
Shawn Connect Telecom www.connecttelecom.us In matters of style, swim with the current. In matters of principle, stand like a rock. Thomas Jefferson
|
|
|
|
Joined: Jun 2001
Posts: 10,631
RIP Admin-Founder
|
RIP Admin-Founder
Joined: Jun 2001
Posts: 10,631 |
Have you checked the ver. on the memory cartrige (which is on the MPD) and the ver. of programming software your using. Make sure they are the same. Other than that. Have you defaulted the system, and then do a full restore...to see if that fixes the problem?
|
|
|
|
Joined: Mar 2001
Posts: 7,350
RIP Admin
|
RIP Admin
Joined: Mar 2001
Posts: 7,350 |
Hold on here, lets not do a default. Your resources look good, Pull out the MPD and get the ver. info off of the memory module. then look at the software ver. when you are in the programming, look up at the right top corner for the ver. that you are using.
Added: As SSPhone posted what is the load area that you are loading, if it is high then your system will reset before the changes are seen. But you shouldn't loose any stations, after it resets itself everything should come up working.
[This message has been edited by dtmf (edited October 31, 2003).]
Russ runs a local service and private tech center. [/url]
|
|
|
Forums84
Topics94,293
Posts638,827
Members49,768
|
Most Online5,661 May 23rd, 2018
|
|
|
|