So to give an update—I did an experiment and just hooked up the rotary adjunct to another rotary set, and realized that both rotaries have to be in series with each other, not parallel. So I made progress and got two rotaries to operate properly on one set. Then when taking that logic over to my 2565 set, hooking up exact way in series, it didn’t like it (volume was muffled until contact was made in rotary, etc). Long story short still looking for a work around. In the BSP it does say some modifications to make, but they are modifications to an autovon set which I don’t have.

Nothing ever happens if you don't show up!