|
|
Joined: Jan 2005
Posts: 15,379 Likes: 13
Moderator-Vertical, Vodavi, 1A2, Outside Wire
|
OP
Moderator-Vertical, Vodavi, 1A2, Outside Wire
Joined: Jan 2005
Posts: 15,379 Likes: 13 |
I was sent out to activate another station on an existing CX installation. The set is a Mitel labeled 4110 set, which I believe is the equivalent to Inter-Tel's 5120 series. Anyway, I'm trying to add this phone to what should be the 13th station port on the system. Ports 1-8 on the first module are cross-connected and ports 1-4 on the second one. I'm using the fifth one.
I get dial tone with a butt set on the first pair and data noise on the second pair, so I'm sure my cable and jacks are good. When the phone is connected, I get talk battery in the handset and the display is fully functional, but the phone doesn't work otherwise. Do I need to get into system programming via X20 to activate this port or is there more to it? I don't think it is programmed as "disconnected" since it should be returning a busy signal when going off-hook under those circumstances. Could it be a polarity issue? Any ideas?
Ed Vaughn, MBSWWYPBX
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
Forums84
Topics94,294
Posts638,834
Members49,769
|
Most Online5,661 May 23rd, 2018
|
|
1 members (Yoda),
102
guests, and
338
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|